Home | About | Products | Dealers | Buying | Cooking | FAQs | Gallery | Contact
Products > EVERHOT 60 > Everhot 60 - Pre-installation guide



The installation of the EVERHOT is a very simple operation that is normally carried out by ourselves or one of our dealers, however it is worth noting the points below and if you follow these simple guidelines it will ensure that everything goes well on delivery day.

NOTE: The preparation of the site, in readiness for the installation of the appliance, is the responsibility of the site owner, not of the manufacturer of the appliance.

The floor must be level and capable of supporting the weight of the cooker (approximate weight 250kg).

The cooker measurements are 600mm deep and 900mm high to the working surface with a width of 600mm The EVH 60 should be installed with a minimum of 30mm clearance from the back wall to allow for the electric cable entry.  This 30mm gap is best sealed by running the worktop behind the cooker, though a standard 30mm stainless infill strip that fits to the back of the cooker is supplied with all new Everhots.  On no account should the cooker be pushed hard against the back wall as this may damage the electric cable. A minimum gap of 5mm per side is required to allow installation and removal of the cooker – please contact us in advance of installation if this is not possible. Where the end grain of a wooden worktop is adjacent to the cooker, we recommend that this is increased to 10mm to minimise the chance of the worktop splitting.

Clearance must be allowed for the raising of the cooker lid(s) into the upright position (minimum height of 1530mm from ground level). Please see side view diagrams for further clarification. A 5mm gap on each side of the cooker lid should be allowed when in the raised position (each lid is 590mm wide to allow for overhead cupboards).

The appliance must be used on 220-240V AC only and should be plugged into a standard 13 amp socket. The 13 amp socket should be accessible and positioned adjacent to the cooker, so as not to impede the opening of the top lid, and ensuring the plug is not exposed to steam or excessive moisture. If the socket cannot be positioned immediately adjacent to the cooker, please see diagrams for exact lengths of cables (unfortunately it is not possible to extend these cable lengths). If the power supply cord is damaged, it must be replaced by the manufacturer or their representative, as special purpose tools are required. An Everhot cooker should NOT be hard wired – please install using the supplied 13amp plug.

The control box is connected to the cooker via a 20mm flexible conduit to allow for a choice of positioning. It may be sited within an adjacent cupboard or on a worktop as required (the control box must not be covered by combustible material or be positioned where contamination with liquids is likely). The control box is not suitable for wall mounting and should remain freestanding in order to facilitate future maintenance. The conduit and power cable should also be easily accessible. Once the position has been decided the control box should not be moved in day to day use. Standard conduit length supplied is 2 metres (unfortunately it is not possible to extend these cable lengths). Where the control box lead is passing through a cupboard this can be done by our installers on delivery. If it needs to pass through a wall or thicker material a 50mm diameter hole should be prepared in advance of the delivery.

Download a printable version of the Everhot 60 installation guide